Monday, May 26, 2008

Spot weld cutter

Took a trip to northern tools to pick up a spot weld cutter. Unfortunately they only had the spring loaded kind and the harden bits. So it was a little squirrelly when I tried to cut some of welds out. Just attached to the old electric drill and started drilling them out. I took a punch and made a small hole for the cutter spring guide. Technique wise, I sped up the drill to its highest rpms and slowly dug in. It was more successful that way - couple of runaway holes though. 28 holes later, the front dash and the upper dash are separated. Allot of small shaving were everywhere.

No comments: